Series
CategoryOthers
SeriesSwitch
MODEL7WHTE-F0-00XX
DescriptionDIP SWITCH
7WHTE-F0-00XX is a DIP switch in KINGCONN's switch series, categorized under Others / Switch. It has a pitch of 1.27 mm and is offered in contact counts of 2, 4, 6, 8, and 10, allowing selection based on the number of circuits required on the board. Switches of this type are used on printed circuit boards for configuration settings, mode selection, and address setting in embedded systems, industrial equipment, and control panels. The part is RoHS compliant, and the engineering drawing (PDF) is available for download on this page.
7WHTE-F0-00XX is part of the KINGCONN Switch series. The catalogue description reads, "DIP SWITCH". Everything on this page comes from source drawing 7WHTE-F0-00XX (revision A), which can be downloaded here.
DIP (through-hole) terminals pass through the board and solder on the far side, which gives the joint more mechanical strength.
The drawing marks this part RoHS compliant.
The KINGCONN Switch series lists 19 models.
Across the series, pitches cover 1.27mm, 2.54mm and 3mm; durability is rated at 2,000, 3,000, 10,000, 30,000, 50,000, 100,000, 200,000, 300,000 or 1,000,000 cycles; contact counts span 2–10 positions — those are series ranges, not this model's values; read the individual drawing for the model you shortlist.
This model's own drawing states: Pitch 1.27 mm; Contact counts 2, 4, 6, 8, 10.
Switch series Board-Level Switch Selection Guide
These application pages set out the connector considerations for each use case:
The engineering drawing (PDF) downloads directly from this page — drawing 7WHTE-F0-00XX, revision A — with dimensions and pin assignment. Every cell of the specification table below comes from that drawing.
For samples or pricing use the RFQ button on this page; the subject line is pre-filled with the part number.
It is a KINGCONN Switch series part. The catalogue description is "DIP SWITCH", and the source drawing is 7WHTE-F0-00XX revision A.
From source drawing 7WHTE-F0-00XX (revision A): Pitch 1.27 mm; Contact counts 2, 4, 6, 8, 10; RoHS compliant. The specification table further down this page lets you check every value.
Email service@kingconn.com.tw with the part number. Clicking any part card on a product page also pre-fills the enquiry subject with that part number. Our sales team will reply with the drawing, samples and pricing.
Yes. The 7WHTE-F0-00XX drawing PDF downloads from this page with dimensions and pin assignment; every cell of the specification table traces back to it.
Source: engineering drawing for this part number 7WHTE-F0-00XX rev. A